The Blade Inductrix ultra micro drone has the modern appeal of a jet with EDF power that makes far less noise while innovative SAFE technology with self-leveling makes staying in control easy, even if it’s your first flight. The Bind-N-Fly (BNF) version of this item requires a few steps in order to connect to a transmitter. The steps below will explain how to “bind” the drone to the transmitter, which is supplied by the customer and could be the source of some issues. General Binding Procedure (BNF) 1. Disconnect the flight battery from the quadcopter. 2. Set the model type in your transmitter settings to “Acro” mode. 3. Center all trims on your transmitter. 4. Power off the transmitter and fully lower the throttle. 5. Connect the flight battery in the quadcopter. The LED on the 3-in-1 control unit fl ashes red during initialization, then fl ashes blue when it is ready to bind. 6. Put the transmitter into bind mode while powering on the transmitter. 7. Release the bind button/switch after 2-3 seconds. The quadcopter is bound when the blue LED on the 3-in-1 control unit turns solid. 8. Disconnect the flight battery and power the transmitter off.